49
FEATURES
Instrumentation
MFD Digital Display Programs
History Program
Press and release the MODE button until the history program screen is
active. This screen will always display electrical system voltage level
and fuel level (if equipped).
Press and release the SET button to cycle through the Maximum Vehicle
Speed, Maximum Engine RPM and Service Interval Reminder screens.
Maximum Speed/Maximum RPM
The gauge automatically logs the maximum
speed and engine RPM even if the history
program is not active in the display.
1. Enter the History Program.
2. Press and release the SET button until
one of the two screens is active.
NOTE: The MPH and RPM values are both
reset at the same time. Reset the val-
ues before each run to obtain accurate
readings.
3. Press and hold the SET button for three
seconds to reset the recorded maximum
values for both MPH and RPM.
NOTE: Due to electrical noise, the MFD may
occasionally display MAX MPH/RPM values that are not representa-
tive of actual values.
To Next Page
Loading...
Need help?
General
