Polaris RANGER ETX INTL 2015 User Manual

3.62
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
11. Lubricate the piston pin with clean engine oil. Install
the piston pin until it seat against the MAG side
circlip.
12.Install the remaining circlip with gap at the 12:00
position. Push the piston pin in both directions to
make sure the clips are properly seated in the groove.
13.After the piston pin and circlip are installed, slide the
cylinder down onto the crankcase.
CYLINDER HEAD ASSEMBLY
NOTE
Assemble the valves one at a time to maintain proper
order.
CAUTION
Wear eye protection during cylinder head disassembly
and reassembly or when working with the valve springs.
1. Apply engine oil to valve guides and seats.
2. Lubricate the valve stems with clean engine oil.
3. Install the valve
u
in the cylinder head, through the
guide.
4. Carefully install a new valve seat/seal
t
,
y
on the
valve guide with a rotating motion. Push firmly until
seated in retaining groove and square with the guide
5. Dip the valve spring
r
and retainer
w
in clean
engine oil.
ENGINE / COOLING SYSTEM

Polaris RANGER ETX INTL 2015 Specifications

General

Brand	Polaris
Model	RANGER ETX INTL 2015
Category	Offroad Vehicle
Language	English