5.14
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
Assembly Procedure
1. Clean the take-up nut
r
threads and install into the
engine to transmission coupler
q
by hand.
2. Insert NEW engine to transmission coupler bolts
e
half way into the engine to transmission coupler.
3. Install the Clutch Center Distance Tool onto the
crankshaft and transmission input shaft. The pictures
below show a properly installed tool.
Clutch Center Distance Tool
PU-50658 or PU-50658-A
NOTE
Images for Reference only. The tool shown should only
be used to check center to center distance.
The location the tool rests on the shafts may vary.
PU-50658–A
HOLE
YEAR
VEHICLE DESCRIPTION
1 2012 RZR 570
2
2011-14 RZR 900
2014-15 RZR XP 1000
2013 RANGER 900
3
2014-16
ACE
2015-18 ACE 570
2015-16
RGR ETX
2013–18 RZR 570
2014–18 RANGER 500/570
2015-18
RANGER 570 Full-Size
4
2014-18 RANGER 900/1000
2015-18 RZR 900
2016-18 RZR 1000
2016–18
ACE 900
5 2015-18
RANGER Diesel
i.e. 2015 RZR 900 uses the holes marked with a 4
4. Turn the upper and then lower take up nuts (4)
counterclockwise (4) to no more than the specified
torque. Repeat the step 4 process.
TORQUE
Engine to Transmission Coupler Take Up Nut:
60 in-lbs (6.7 Nm)
IMPORTANT
Do not over-torque the take up nuts. Torque nuts using
the sequence described in step 4. If too much torque is
applied to the take up nuts, the transmission mounting
ears may break.
PVT SYSTEM
To Next Page
Loading...
Need help?
General
