6.16
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
5. In sequence, torque the eight engine coupler bracket
fasteners to specification.
TORQUE
Engine to Trans Coupler Fasteners
In Sequence:55 ft-lb (75 Nm)
6. Remove the clutch center distance tool.
7. Remove the spacer or support between the vehicle
frame and engine.
8. Install and properly route the gear position switch
connector (Item 8), speed sensor connector (Item 9),
crankshaft position sensor connector, shift bracket
bolts (Item 10), shift bracket (Item 11), shift cable
clevis pin and washer (Item 12) onto the
transmission.
9. Torque the (2) shift cable bracket bolts to
specification.
TORQUE
Shift Cable Bracket Bolts:
37 ft-lbs (50 Nm)
10. Install three wire ties to retain wire harness to
transmission and mounts.
11. Install and properly route the vent hose.
12. Lubricate the transmission splines and mid prop
shaft joint splines with Polaris All Purpose Grease.
Install the prop shaft onto the transmission output
shaft (see Chapter 7).
13. Install inner clutch cover, outlet duct, drive clutch,
driven clutch, belt and outer clutch cover (see
Chapter 6).
14. Install new spring ring (Item 13) on rear drive shafts.
Apply an anti-seize compound to the splines (Item
14).
TRANSMISSION
To Next Page
Loading...
Need help?
General
