5.22
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
13. Remove thrust bearing from output hub and inspect
for wear.
14. Remove output hub (G) from cover. Inspect bearing
(F) and dowel (H).
15. Inspect the magnetic coil (I) in the output housing.
NOTE
AWD Diagnosis, page 5.16
16. Inspect back lash pad (J) for excessive wear.
NOTE
The backlash for the centralized hilliard is set at the
factory. Adjustment is required only when related parts
are replaced or the back lash pad screw is removed.
Minor adjustments can be made to address noise. See
the "Backlash Pad Adjustment” procedure later in this
chapter for details on backlash setting.
17. Inspect the output hub Garlock bushing (K) for
scoring and wear.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
