ENGINE ERROR CODES
The error screen displays only when the CHECK ENGINE indicator is on or
when it goes on and off during one ignition cycle. Error codes are not stored.
When the key is turned OFF, the code and message is lost, but will reappear if
the fault reoccurs after restarting the engine.
If the CHECK ENGINE lamp or the EPS lamp illuminates, retrieve the active
error codes from the display.
q
Failure Mode Indicator (FMI)
w
Suspect Parameter Number (SPN)
e
Code Count
1. Press and hold the MODE button to enter the settings menu.
2. Press either toggle button to cycle to the “DIAGCODE” option. Press MODE
to select.
3. More than one diagnostic code may be present. Press the toggle UP button
to see if more codes are present. Press MODE to select a code.
NOTE
If the displayed code is an engine fault code, the CHECK ENGINE lamp will
blink. If the displayed code is an EPS fault code, the EPS lamp will blink.
4. Record the three (3) numbers displayed.
5. Press MODE to exit to the settings menu.
57
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
