Page | 34
WELDER
______________________________________________________________________
Your machine has been fitted with welder capability for steel posts operations.
The welder power pack is built into the, with connections and on/off switch located on the
side of the machine. The welding output is totally isolated from the machine electrical
circuit.
To operate the welder, manually move the lever at the rear of the machine to control the
hydraulic motor which drives the welder power pack.
Turn the toggle switch to the `ON` position, this will be confirmed by the internal led on
the toggle being illuminated.
Connect welding leads, and adjust the rotary control for desired power.
To Next Page
Loading...
Need help?
General
