Jun. 2020 / Rev.0.1 DS-UB40.241-EN All values are typical figures specified at 24Vdc input voltage, 40A output current in
power supply mode at 25°C ambient, no charging and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
22.2. ZM12.SIDE - SIDE MOUNTING BRACKET
This bracket is used to mount the power supply sideways with or without utilizing a DIN-Rail.
The two aluminum brackets and the black plastic slider of the unit have to be detached, so that the steel brackets can
be mounted.
For sideway DIN-rail mounting, the removed aluminum brackets and the black plastic slider need to be mounted on
the steel bracket.
Fig. 22-7
Side mounting without DIN-rail
brackets
Fig. 22-8
Side mounting with DIN-rail
brackets
Fig. 22-9
Mounting Dimensions
Side mounting bracket
22.3. UZS24.100 – SENSOR BOARD FOR DC-UPS
The UZS24.100 enables all the benefits of the PULS 1-Battery-Concept
when using individual batteries and not one of the UZK24 battery
modules. This sensor board makes the use of matched batteries
unnecessary and allows a precise battery charging and testing
resulting in the longest possible battery life. The sensor board
contains a PT1000 temperature sensor and an auto-resettable fuse.
The fuse protects the center-tap wire between the battery module and the DC-UPS control unit.
To Next Page
Loading...
Need help?
General