11
Enforcer
Time 8:30am c
Enter Your Code
[*****]
SET DATE & TIME?
CHANGE CODES?
Change User
Codes?
User Number [02]
Enter user code
[ ]
Enter user code
[******]
User Name
_
Select Button
Lock [1]
Button Action[2]
Set Area
Learning Keyfobs
The master manager menu has to be used to
assign keyfobs to the user codes. Follow the
instructions to the right to enter the master manager
menu (for more information please see the user
manual).
A maximum of 32 keyfobs can be assigned to the
Enforcer.
Each keyfob has 4 buttons that can have specic
operations:
[0] No action: Disables the button
[1] Show Status: If the keyfob is learnt, the LED will
icker when the nominated button is pressed.
GREEN = Unset. RED = Set.
[2] Set Area: Sets the chosen area
[3] Unset Any Area: Unsets any area on the system
[4] Latch Output: Latches an output (programmable)
when the nominated button is pressed.
[5] Timed Output: Activates an output for a period of
time (programmable in seconds)
Before learning each keyfob check that the battery is
present and inserted correctly.
When learning a keyfob, any button must be held until
the LED ashes GREEN and RED, and then when
released, a GREEN LED will be shown, asterisks
will appear in the brackets on the keypad and an
acknowledgement beep will be heard, all indicating a
successful learn.
Keyfob buttons can also be programmed in the
engineer menu, in the same way as shown here
(please see the programming manual for more
information)
Deleting Keyfobs
To delete a keyfob/user code, press the c key when
the display shows ‘Enter a user code’ on the chosen
code and the astericks on the display will erase. Press
t to accept
D
A
B
C
SPACE
1
4
7 8
5
2
3
6
9
0
,/+.
ABC
JKL
MNO
PQRS
TUV
WXYZ
DEF
GHI
BYP
Day mode
Press d
Enter master
manager code
Press
x
Press
t
Press
t
Select User, Press
t
Press and hold any
button on the keyfob
until the RED and
GREEN LEDs flash,
then release.
Asterisks will appear,
Press
t
Enter Name. Press
t
Use [].Press
t
Use [] Press
t
To Next Page
Loading...
Need help?
General
