Pyronix Enforcer 32WE Setup Guide

27
SHOCK-WE
Wireless transmitter with wall tamper and shock sensor
When you are ready to learn the device to the control panel receiving equipment, and when the
equipment is in the learn mode (see Enforcer Programming Manual) follow the procedure below.
1. Make sure the battery is installed correctly and the plastic wrapping removed.
2. Press and Hold the Learn button until the 3 LEDs start cycling through the different colours, then
release the Learn button.
3. The device is correctly learnt when the Green LED flashes.
The three coloured LEDs give a visual indication of the signal strength.
Green indicates good signal strength and is a good location to install.
Red indicates poor signal strength and the device should not be
installed in that position.
If no LED illuminates then the device is completely out of range.
The blue LED will illuminate when the device is activated.
Learning the SHOCKWE to the Enforcer control panel
Back view of the MC1-WE
Tamper Switch
Using Magnetic Contact 1 (S1)
To enable Magnetic Contact 1 you must remove the
jumper link from the S1 enable pins:
Door
Door Frame
Reed Switch
S1
S1 Enable
Learn
S2 Enable
Z T
Test Result
T
C
Z
WINDOW
Contact
Magnet
TAMPER
Tamper
Enable/
Disable
Zone
Enable/
Disable
Magnetic
Contact 1
Enable/
Disable
Learn
Button
Status LEDs
ZONE
S1
S1 Enable
Learn
Z T
Test Result
T
C
Z
Example:
Universal Transmitter
T
C
Z
Z T
T
T
N / C
Door
Contact
/ Sensor
+
-
S1
S1 Enable
Learn
Z T
Test Result
T
C
Z
CR2 Battery
CR2 Battery
If the battery needs to be replaced, the
correct battery type (CR2) must be
installed
RED BLUE GREEN
RED BLUE GREEN
RED BLUE GREEN
RED BLUE GREEN
RED BLUE GREEN
MC1-WE
WHITE
3mm ABS, 0.4mm HDPE in Lens Area
868MHz, FM Transceiver Narrow Band
Fully Encrypted Rolling Code
300m Free Space
Three LED Combinations
(RSSI, Battery Status and Alarm)
1 x MC1-WE
2, Side and End
1 External Input & 1 External Tamper Input
3.6V 2.2Ahr AA Lithium Battery
Up to 2 Years
Front+Optional Rear Tamper
-20°C to 50°C
-10°C to 50°C
Model:
Colour:
Casing:
Transmission Frequency:
Transmission Method:
Transmission Range:
Indication:
Reed Switch:
Detection Points:
Detection Inputs:
Battery:
Battery Life:
Tamper Switch:
Storage Temperature:
Operating Temperature:

Pyronix Enforcer 32WE Specifications

General

Brand	Pyronix
Model	Enforcer 32WE
Category	Security System
Language	English