TMS STRING PINSPOTTER OWNER’S MANUAL
400-051-010-01 Rev. Date: 7/17 Page 1-5
The wires of the power supply cord must be at least 14 AWG (2.5 mm
2
) in cross
section.
Lockout/tagout procedure is to be implemented in the facility. Shutoff and
lockout/tagout (LOTO) machine before entering the machine or doing anything
on the ball return. A lock-out device should be placed over the power connector
to prevent power from being applied to the machine during maintenance or repair.
For an individual machine, noise amplitude in the area behind or in front of the
machine will exceed 80dBA and reach 110dBA for short periods during the
impact of bowling. With multiple adjacent machines in operation, significant
noise amplitude will superimpose and become more persistent. Hearing
protection must be used while working near the pinspotter area in the back.
When conducting repair or maintenance in the pit area, use of extra lighting is
essential.
The end user of the machine must provide sufficient ambient lighting for the
general area of the machine.
The end user or operator must ensure that there is no access to the machines from
the front or sides after the guards provided are installed. Do not allow bowling to
occur on a lane with a machine that is being serviced. Place a physical barrier at
the approach or otherwise ensure that no ball is thrown if an operator must access
the pit area. Do not allow movement at the front of the pinspotter between a
machine under service and a machine with active play.
All guards provided are installed by certified QubicaAMF personnel, tested and
checked for function.
Safety goggles and steel-toed shoes are recommended whenever any work is
being performed on a pinspotter.
Use caution moving between levels to service the machine. Always use approved
steps and railings. Do not enter unprotected areas. This symbol indicates a fall
hazard.
Indicates a tripping hazard. Use caution around known, marked obstructions.
Do not stand on areas where this decal is shown.
Use pin-hook for all activity inside the pit. Use pin-hook to retrieve pins, perform
detangle, or move ball from position outside the pit.
To Next Page
Loading...
Need help?
General
