TMS STRING PINSPOTTER OWNER’S MANUAL
400-051-010-01 Rev. Date: 7/17 Page 1-15
BALL STEP – Causes the controller to switch the selected machine from a
first ball to a second ball condition or from a second ball to
a first ball condition without cycling the pins.
MODE – Cycles the selected pinspotter between the current mode
and the Mechanics Mode.
EXIT – Returns the controller to the previous menu level. Pressing
it a second time returns the controller to the main screen.
DIAGNOSTICS – Allows the user to view the state of the various system
(DIAG) components.
MCU – Allows access to the Settings, Functions, and Counters
submenus.
HELP! – Press and hold to display a brief message about the current
screen or menu selection.
TROUBLE CLEAR – Press to clear error messages. Requires a password. Must
(TRBL CLEAR) fix the machine fault first. For example, a tripped breaker
must be closed before the error message can be cleared.
PROGRAM ZERO – Stops the string untangle routine.
(PROG ZERO)
Passwords
To prevent unauthorized changes to your machine’s software settings, most keypad and
control chassis functions are password protected. There are three passwords which are
entered by pressing specific combinations of keypad arrow pushbuttons. The first
password is the Trouble Clear Password. This is used to activate the TRBL CLEAR
pushbutton on the keypad. A password is necessary because pushing this button to clear
an error message can cause the machine to cycle (depending on the fault being cleared).
The second password, the General password, is required any time the MCU, CYCLE,
*HOME, or MODE pushbuttons are pressed. These buttons allow the user to change
machine functions, and is necessary to prevent unauthorized changes. The third
password is the Output Control password. This enables control of individual outputs for
diagnostic purposes. It is accessed from the diagnostic menu.
*No password is required for the HOME button if 10_PINS_SWAPPED mode is selected.
There is a fourth password (that is not provided) that is required to change the game type.
The game type is set during machine installation and should never need to be changed.
The password is necessary because setting the chassis to the wrong game type for your
installation will cause the machine to malfunction. The Game Type is for installers and
Technical Support personnel and is not disclosed in this manual.
Trouble Clear Password: (UP-DOWN-UP-DOWN-RIGHT)
General Password: (DOWN-LEFT-UP-RIGHT-UP-LEFT-DOWN)
Output Control Password: (UP-RIGHT-RIGHT-DOWN-LEFT-LEFT-UP)
To Next Page
Loading...
Need help?
General
