13
5. BASIC FUNCTIONS OF THE INSTRUMENT
Electronic balance is appropriate for precise measurements mass in laboratory
conditions with possibility of setting to zero in all measure range. Balance
calibration is done by CAL on balance keyboard.
9 Functions for weighing units (press Units key)
- select default units of weighing <StUn>,
- Weighing in grams,
- Weighing in [mg],
- Weighing in [ct],
- Weighing in units from beyond SI (only: [oz], [ozt], [dwt], [t], [mom], [gn],
Access to these units is blocked from factory menu level,
9 Functions for calibration and weighing modes
- Counting pieces < PIECES>,
- Control +/- <HiLo>,
- Control of deviations % according to standard mass <Perc A>,
<Perc B>,
- Thickness of liquids <d_Li>or solids <d_Co>,
9 Choice of criteria of stable result depending on usage conditions
- Turn off/on system of autozero <AUTO>,
- Average result of weighing <AvE>,
- Back light function<bl>,
- Beep signal <bEEP>,
9 Function for using RS 232
- Choose speed of transmission,
- Define sent data as: stable / not stable,
- Continuous work,
- automatic work for RS 232.
Moreover balance can be used to weigh hang loads, print report of calibration,
check deviation of calibration and print reports of testing thickness of liquids and
solids.
To Next Page
Loading...
Need help?
General