63
14.3. Setting type of operating for RS 232 joint
Proc
edure:
rEPL no – manual operating / after pressing PRINT key
rEPL YES - automatic operating / after stabilization of weighing
result.
Return to weighing
(see - 7.1.2. – return to weighing).
Automatic operating takes place according to following scheme:
press TARE key to zero the balance (display will indicate marker of
stable measurement and marker of zero)
place the load, balance will send through the RS232 first stable
measurement
remove load from the pan,
next measurement will be possible when weighing result +/- 50
reading units referring to zero (by next measurement zero stat is not
required).
To Next Page
Loading...
Need help?
General