17
7.1. Moving in user menu
User moves in menu using balance keyboard (see point no 6)
7.1.1. Return to weighing function
Introduce
d changes in balance memory will be saved for good after
return to weighing with procedure of saving changes. Press several
times Esc key until display indicates message SAvE?.
When display indicates question press if necessary: PRINT/ENTER –
confirmation of changes or ESC – resignation from introduced changes.
After pressing appropriate key, balance will go back to weighing.
8. WEIGHING
Before
weighing or if the conditions of work changes (e.g. if temperature of
surrounding is higher then 3
o
C) balance should be calibrated.
• Balance should be loaded few times by mass close to max capacity before
taking measurements,
• Check if not load balance shows „precise zero” - if measurement is
stable - order , if not press key →0/T←,
• by means of Units key set measure unit : [g], [mg], [ct], and if they are
accessible in factory menu [oz], [ozt], [dwt], [t], [mom], [gn],
• put load on balance and read result on display ,
• indication can be setting to zero many times by pressing key Esc/TARE
(summary of mass loads record to balance memory cannot be bigger then its
max capacity).
To Next Page
Loading...
Need help?
General