2. BASIC INFORMATION
2.1. Intended use
The purchased balance serves to determine the weighing value of loads in
laboratory environment. It is intended for application as a non-automatic
weighing instrument only, i.e. the material to be weighed is manually and
carefully placed in the center of the weighing pan. Weighing result should be
read only after stable reading has been obtained.
2.2. Inappropriate use
Do not use the balance as a dynamic weighing instrument. Even if small
quantities of weighed material are added or removed from the weighing pan of
the instrument, the reading should be taken only after stabilization of the
measurement result. Do not place any magnetic materials on the weighing pan,
as this can cause damage of the measuring system of the instrument. Be sure
to avoid impact shock and overloading the balance in excess of the prescribed
maximum measuring range (max capacity), minus any possible tare weight that
has been applied. Never use the balance in an environment endangered by an
explosion. This balance has not been adjusted for operation in explosive areas.
There must not be any modification made to the balance.
2.3. Warranty
Warranty is not valid at the following:
• Non-observation of the guidelines of this user manual,
• Use of balance other than specified in this manual,
• Alternation to or opening of the device,
• Mechanical damage and damage caused by media, natural water,
and tear,
• Inappropriate assembling or defects of electric installation,
• Overloading of the measuring instrument.
To Next Page
Loading...
Need help?
General