21
Adjustment types:
• external adjustment performed using an external weight of declared mass,
i.e. mass that cannot be modified,
• user adjustment performed using an external weight of mass of any value
comprised within the weighing range, however not lower than 30% of the
maximum capacity value.
• automatic internal adjustment,
• manual internal adjustment.
In case of verified scales only two adjustment types are
available: automatic internal adjustment and manual internal
adjustment. Remember to carry out the adjustment process
when there is no load on the pan! When the weighing pan
is loaded with too heavy load, message <Err4> is displayed.
In such case, unload the weighing pan and repeat the
adjustment. Adjustment process can be aborted if necessary
at any time, to do it press
key.
12.1. External Adjustment
option available for non-verified scales exclusively
External adjustment must be carried out using an external adjustment weight
of class F
1
, adjustment weight mass is conditioned by scale type and maximum
capacity.
Procedure:
• Enter <P1.CAL / 1.1.CA-E> submenu, text <UnLoAd> (remove weight)
is displayed.
• Remove the load from the weighing pan and press
key.
• Mass of an empty weighing pan is determined, this is signalled with
display of 'dash', < - >. Next, text <LoAd> (load weight) and mass
value that is to be loaded, e.g. 2000 g (conditioned by scale type), are
displayed.
• Load the weighing pan with weight of specified mass value and press
key
.
• Weight mass is determined, this is signalled with display of 'dash',
< - >. Next, text <UnLoAd> (remove weight) is displayed.
• Remove the load form the weighing pan, <1.1.CA-E> submenu
is displayed.
To Next Page
Loading...
Need help?
General
