46
24.2. Peak Hold Operation
• Enter <3.5.toP / 3.5.2.Lo> submenu, set <Lo> parameter value
(Lo threshold) after exceeding of which maximum force is to be registered.
• Enter <toP> working mode (Peak Hold). From now on the scale registers
and holds every single weighing which is above the Lo threshold, and
which is higher than the result of the previous peak hold. Snapped peak
hold value is signalled by <Max> pictogram displayed at the top of the
screen.
• The start of the next process of peak hold measurement is possible only
after removing the load from the weighing pan and pressing
key.
• This causes returning to the home screen of <toP> mode. Pictogram
<Max> is automatically deleted.
25. WORKING MODE – TOTALIZING
Totalizing is a working mode enabling you to sum mass of all weighed
ingredients, and to print (via scale-connected printer) the total mass value. The
program allows you to sum up to 30 weighings (ingredients) maximum within
one process.
25.1. Local Settings
To go to local settings enter <3.6.Add> submenu.
3.6.1.Acc
Working mode accessibility
For detailed description read section 19.2.1.
3.6.2.Snn
Save mode
For detailed description read section 19.2.2.
3.6.3.Int
Time interval
For detailed description read section 19.2.3.
3.6.4.Lo
Lo threshold
For detailed description read section 19.2.4.
25.2. Totalizing Operation
• Enter <Add> working mode (Totalizing), blinking „▲” pictogram
is displayed.
• If the ingredients are to be weighed in a container, first put the container
on a weighing pan and tare it.
• Load the weighing pan with the ingredient no.1. When the indication
is stable (
pictogram is displayed), press key to confirm the mass.
• Total mass value is displayed, now the „▲” pictogram is displayed
continuously.
To Next Page
Loading...
Need help?
General
