39
19.2. Working Modes Local Settings
Each working mode features specific (local) functions which enable adapting
device operation to individual needs. The functions are to be found in local
settings. To go to local settings of each working mode enter <P3.Func>
submenu. Some special functions are available for all working modes, refer to
the table below:
Accessibility Save mode Time interval Lo threshold
Weighing 3.1.1.Acc 3.1.2.Snn 3.1.3.Int 3.1.4.Lo
Parts counting 3.2.1.Acc 3.2.3.Snn 3.2.4.Int 3.2.5.Lo
+/- control 3.3.1.Acc 3.3.2.Snn 3.3.3.Int 3.3.4.Lo
Percent weighing % 3.4.1.Acc 3.4.3.Snn 3.4.4.Int 3.4.5.Lo
Peak Hold 3.5.1.Acc - - 3.5.2.Lo
Totalizing 3.6.1.Acc 3.6.2.Snn 3.6.3.Int 3.6.4.Lo
Animal weighing 3.7.1.Acc - - 3.7.3.Lo
The table presents special function number and name for each of the working
modes. Remaining specific functions referring directly to a given working mode
are described further down this user manual.
19.2.1. Working Mode Accessibility
To enable/disable given working mode, press
key.
Procedure:
• Enter <P3.Func> menu and select given working mode.
• Go to <Acc> function.
• Press
key, parameter values are displayed successively one by one:
YES – working mode enabled, no – working mode disabled.
• Press
key to confirm, next go to the home screen.
19.2.2. Save Mode
Parameter allowing you to set mode of sending data from the weighing device
to a peripheral device.
Procedure:
• Enter <P3.Func> menu and select given working mode.
• Go to <Snn> function.
To Next Page
Loading...
Need help?
General
