Appendix B: Error and Warning Codes
Possible BreadCrumb error and warning codes are listed below.
A BreadCrumb can have multiple errors or warnings listed in the Alerts tab of BC|Commander but only
one code will be flashed on the BreadCrumb’s status LED. A few codes such as 811 and 335 are non-flash-
ing alerts. For a BreadCrumb with other active alerts, the lowest number error code will flash on the
BreadCrumb’s status LED, and if there are no errors then the lowest number warning will flash.
Numeric error codes are flashed as groups of red (error) or yellow (warning) LED blinks. For example, a
meshed BreadCrumb displays a green LED. If the BreadCrumb starts to display warning 37, the following
would be seen: green (link state), yellow blinks 3 times, short pause, yellow blinks 7 times, long pause of
green (link state), yellow blinks 3 times, short pause, yellow blinks 7 times, etc.
Model-specific differences:
JR models have multiple green LEDs. JR’s flash error codes on the ERR LED and warnings on the
WARN LED.
DX2 models have a bicolor green/red LED. Both errors and warnings are flashed in red.
SlipStream does not have a soware-controllable LED and cannot display warning/error codes. Use
BC|Commander to view error status.
Code Firmware Upgrade Codes (1*)
11 Flash image file does not exist.
12 Current flash image version is greater than versions of files found on USB drive.
13 No flash image files found.
14 Unable to mount USB drive.
16 Continuous Transmit Mode
115 Copying failed.
116 Flash unbundle failed.
117 Version information in flash file name and breadcrumb-buildinfo.conf do not match.
1171 Platform information in flash file name and breadcrumb-buildinfo.conf do not match.
118 Untar failed.
119 FIS directory update of kernel failed.
125 Failed to set boot path to next image.
127 Failed to copy file system image.
135 Failed to copy init image.
136 Failed to copy bootloader image.
137 This flash image may not be installed onto this BreadCrumb.
142 The version you are installing does not support the configured Packet Cipher
143 The version you are installing does not support the configured MAC Address Cipher
144
The version you are installing does not support the configured Per-hop Authentication
algorithm
145 The version you are installing does not support the configured security policy
146 Failed to verify consistent country settings
To Next Page
Loading...
Need help?
General
