Rajant BreadCrumb ES1-2450R User Manual

Anatel:
Compliance Information (ANATEL): Este equipamento não tem direito à proteção contra interferência
prejudicial e não pode causar interferência em sistemas devidamente autorizados. Para maiores
informações, consulte o site da ANATEL –  http://www.anatel.gov.br.
CE:
Rajant Corporation declares that the ES1-2450R and ES1-5050CS are in compliance with the essential re-
quirements and other relevant provisions of Directive 2014/53/EC.
IMPORTER - CMI Corporation Limited
Catteshall Road,Godalming, Surrey GU7 INJ, UK
CE Declaration of Conformity may be requested from Rajant.


NOTE
NOTE
Please refer to the product spec sheet at
Please refer to the product spec sheet at


http://www.rajant.com
http://www.rajant.com
for a list of certified model numbers.
for a list of certified model numbers.
Antennas


Antenna Installation WARNING
Antenna Installation WARNING
The installer should configure the conducted output power level according to country regulations and
The installer should configure the conducted output power level according to country regulations and
the applicable equivalent isotropically radiated power (EIRP) limit. Professional installation of equip-
the applicable equivalent isotropically radiated power (EIRP) limit. Professional installation of equip-
ment is required to ensure compliance with health and safety issues.
ment is required to ensure compliance with health and safety issues.
Required Antenna Separation
The antennas from any transceiver of the BreadCrumb ES1 may not be co-located with the antennas of
any other transceiver. The co-location restriction is satisfied by maintaining 20 cm separation between
the antennas of different transceivers. There is no restriction for the separation between the antennas
from the same transceiver; but testing at installation is recommended to verify the system performance
achieved with a specific antenna deployment.


Warning
Warning
Because the BreadCrumb ES1 case is plastic, antennas should not be directly attached and should be
Because the BreadCrumb ES1 case is plastic, antennas should not be directly attached and should be
attached using only antenna cables. This is to avoid stressing the plastic and compromising the IP67
attached using only antenna cables. This is to avoid stressing the plastic and compromising the IP67
ingress rating. Low loss cable, such as LMR-400, is recommended for externally attached antennas.
ingress rating. Low loss cable, such as LMR-400, is recommended for externally attached antennas.


Warning
Warning
For all BreadCrumb models, for installations that will experience vibration or shock, all antennas should
For all BreadCrumb models, for installations that will experience vibration or shock, all antennas should
be externally mounted and attached using cables. Low loss RF cable, such as LMR-400, is recommended
be externally mounted and attached using cables. Low loss RF cable, such as LMR-400, is recommended
for cable attached antennas.
for cable attached antennas.


Warning
Warning
If a radio port is not required for a given application, the port should be disabled in BC|Commander and
If a radio port is not required for a given application, the port should be disabled in BC|Commander and
a 50 Ohm terminator should be installed.
a 50 Ohm terminator should be installed.
Figure: Incorrect Antenna Placement
7

Rajant BreadCrumb ES1-2450R Specifications

General

Brand	Rajant
Model	BreadCrumb ES1-2450R
Category	Network Hardware
Language	English