Instrument Tour
R&S
®
RTM2000
17Getting Started 1317.4710.02 ─ 05
NAVIGATION
The function of this universal rotary knob depends on the usage context:
●
If a softkey with numerical entry or selection menu is selected, turn the knob to set
a value.
●
Pressing the knob closes the selection menu.
●
If the cursors are on, press the key to select a cursor line. Turn the knob to change
the position of the selected cursor line.
●
If an input editor is open – on-screen keypad or on-screen keyboard – turn the
knob until the required character is highlighted, then press the knob to apply it.
UNDO
Reverses the last setting actions step by step. The "Undo" is not possible after preset,
load and recall actions, and creating a reference waveform.
REDO
Recovers the undo steps in reverse order.
3.1.4 ANALYZE Keys
The keys in the ANALYZE functional block open various menus for signal analysis.
PROTOCOL LOGIC
Opens the "Protocol" and "Logic" menus, where you can select and configure serial
interfaces and bus systems, and configure digital channels for analysis.
If the "Protocol" menu is selected, the key toggles the bus.
The "Logic" menu and digital channels are only available if option R&S RTM-B1 (MSO)
is installed.
TOOLS
Opens the "Tools" menu where you can start further applications of the R&S RTM:
●
Masks Test. Masks are used for error detection and compliance tests of signals.
●
Power Analysis. Option that performs various power measurements.
FFT
The FFT key activates and deactivates the spectrum analyses functions:
Front Panel
To Next Page
Loading...
Need help?
General
