R&S RTM2000 Series User Manual

Instrument Tour
R&S
®
RTM2000
19Getting Started 1317.4710.02 ─ 05
If the trigger type has one trigger leven, pressing the knob sets the level to 50% of the
signal amplitude.
If the trigger type requires two trigger levels, for example, the rise time/fall time trigger,
pressing the knob toggles between upper and lower level.
If a B-trigger is enabled, the knob can set the level for both the A- and B-trigger. To
assign the level to the A- or B-trigger, use "Trigger Level" in the "Trigger" menu.
SETUP
Opens the "Trigger" menu.
SOURCE
Opens the "Trigger Source" menu for the A-trigger. Press the key repeatedly until the
required source is selected. The key lights up in the color of the selected trigger chan-
nel. The selected source is shown in the information bar.
SLOPE
If you have selected "Edge" trigger as trigger type with an analog trigger source, the
SLOPE key toggles the trigger slope. The current setting is shown by an icon in the
information bar.
If a B-trigger is enabled, the key can set the slope for both the A- and B-trigger. To
assign the slope to the A- or B-trigger, use "Trigger Level" in the "Trigger" menu.
3.1.6 VERTICAL Controls
The keys and knobs in the VERTICAL functional block select a signal and adjust the
vertical scale and position of the selected waveform.
Front Panel

R&S RTM2000 Series Specifications

General

Brand	R&S
Model	RTM2000 Series
Category	Test Equipment
Language	English