To Next Page

To Previous Page

Trying Out the Instrument

R&S

RTM2000

34Getting Started 1317.4710.02 ─ 05

7. Press "Measure 2" until "On" is highlighted.

8. Press "Meas. Type" until "Base Level" is highlighted.

9. Press "Source" until "CH1" is highlighted.

The top and base level values of the active signal are displayed in the result table.

10. Press QUICK MEAS to turn off the quick measurement mode.

4.5 Performing Cursor Measurements

While the quick and automatic measurements provide results for the entire (visible)

waveform or at pre-defined points, a cursor measurement allows you to specify at

which points in the diagram you require results. Depending on the type of measure-

ment, two or three cursors are positioned on the screen and the results for those points

are displayed.

For example, using the voltage & time cursor measurement, you can position two verti-

cal cursors at the pulse edges and the horizontal cursors at the levels. Thus the pulse

width as well as top and base level voltages are measured.

Performing Cursor Measurements

Questions and Answers:

Need help?

Do you have a question about the R&S RTM2000 Series and is the answer not in the manual?

R&S RTM2000 Series Specifications

General