To Next Page

To Previous Page

Trying Out the Instrument

R&S

RTM2000

35Getting Started 1317.4710.02 ─ 05

1. Press the CURSOR key.

The cursor lines are switched on.

2. Press "Meas. Type" until "Voltage & Time" is highlighted.

3. Press "Source" until "CH1" is highlighted.

4. Press the NAVIGATION rotary knob to select the first cursor. Turn the rotary knob

to move the cursor line to the beginning of a pulse.

5. Press the NAVIGATION rotary knob again to select the second cursor. Turn the

rotary knob to move the cursor line to the end of the pulse.

6. Repeat the step to position the horizontal cursors.

The following results are displayed in the result table.

● Δt: pulse width

● t1, t2: time of the cursor positions, measured from the trigger point

● ΔV: difference between top and base level

● V1: top level voltage

● V2: base level voltage

Performing Cursor Measurements

Questions and Answers:

Need help?

Do you have a question about the R&S RTM2000 Series and is the answer not in the manual?

R&S RTM2000 Series Specifications

General