To Next Page

To Previous Page

Trying Out the Instrument

R&S

RTM2000

33Getting Started 1317.4710.02 ─ 05

Automatic measurements

To obtain more complex measurement results, or results from several channels simul-

taneously, you can configure up to four amplitude and time measurements or pulse

counts, based on the active signal or math waveforms.

For example, you can compare the amplitudes of an active signal waveform with those

of a reference waveform. In the following example you will determine the top and base

levels of the first pulse in the signal. The results are displayed in the result table below

the diagram.

1. Press the MEAS key.

2. Press "Meas. Place" until 1 is highlighted to select the first of the four measurement

positions.

3. Press "Measure 1" until "On" is highlighted.

4. Press "Meas. Type" until "Top Level" is highlighted.

5. Press "Source" until "CH1" is highlighted.

6. Press "Meas. Place" until 2 is highlighted to configure the second measurement

position.

Showing Basic Measurement Results

Questions and Answers:

Need help?

Do you have a question about the R&S RTM2000 Series and is the answer not in the manual?

R&S RTM2000 Series Specifications

General