To Next Page

To Previous Page

Operating the Instrument

R&S

RTM2000

45Getting Started 1317.4710.02 ─ 05

●

Another group of function keys directly start an action or change a parameter - for

example, AUTOSET, PRINT, RUN CONT, MODE.

●

The FFT and ZOOM keys start the corresponding display mode and open the

associated menu.

To leave the display mode:

– If the main menu of the mode is shown, press the function key once.

– If a submenu of the mode is shown, press the function key twice - first to return

to the main menu and second to close the display mode.

– Press the "Off" softkey in the main menu of the mode.

Using menus

A menu can have several menu levels. If a lower menu level is available, it is indicated

by a small arrow on the softkey. If a menu level has more than 7 functions, they are

arranged on two or more pages. The "More" key on the right switches the menu page.

It shows the overall number of pages on the current menu level and the number of the

selected page.

Fig. 5-2: Channel menu: "Probe", "Threshold" and "Label" open submenus, "More" switches the

menu pages

1. Press the function key.

The associated menu opens.

2. If the required function is not in the menu, press the "More" softkey on the right to

browse the menu pages.

3. To return to a higher menu level, press the "Back" softkey on the right.

Selecting a value

Many parameters are set by selecting a parameter value. If there are only two or three

values available, they are shown directly on the softkey. More values are provided in a

selection menu.

1. To select a value on the softkey, press the key until the required value is highligh-

ted.

2. To select a value from a selection menu, use one of these ways:

Accessing the Functionality

R&S RTM2000 Series User Manual

Questions and Answers: