To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...Why does my Raymarine E140 GPS display not start up?
The display may not start due to a problem with the power supply. Check the following: * Relevant fuses and breakers. * The power supply cable, ensuring it is sound and all connections are tight and free from corrosion. * The power source, making sure it is of the correct voltage and sufficient current.
What to do if my Raymarine GPS shows a 'No Fix' status?
If your Raymarine GPS displays a 'No Fix' status, the issue could be due to several reasons: * Your current geographic location or weather conditions might be preventing a satellite fix. Periodically check to see if a fix is obtained under better conditions or in a different location. * There may be a fault with the external GPS connection. Ensure that all GPS connections and cabling are correct and fault-free. * The external GPS antenna might be poorly positioned, such as being below decks or too close to transmitting equipment like a VHF radio. Ensure the GPS antenna has a clear view of the sky.
Ensures product is installed and operated per Raymarine instructions to prevent injury or damage.
Product not approved for hazardous/flammable atmospheres. Do not install near fuel tanks.
Product contains high voltages. Do not remove covers or access internal components.
Ensure product is correctly grounded before applying power.
Switch off boat's power supply before installation. Do not connect/disconnect with power on.
Ensure all personnel are clear before rotating the radar scanner.
Scanner transmits electromagnetic energy. Ensure personnel are clear when transmitting.
Never operate sounder out of water; avoid touching transducer face when powered.
Ensure power source is protected by a suitably-rated fuse or automatic circuit breaker.
Ensure correct installation for EMC performance; maintain separation from other equipment and cables.
Lists the key activities for system installation, from planning to final testing.
Illustrates basic system connectivity for the E-Series Widescreen display.
Explains various protocols (SeaTalkhs, SeaTalkng, NMEA 2000, SeaTalk, NMEA 0183) for system connectivity.
Designates a multifunction display as the primary data source for networked systems.
Provides guidelines on cable types, routing, strain relief, circuit isolation, and shielding.
Details the correct power connection for the display, including distribution and protection.
Explains how to connect compatible displays and devices using the SeaTalkhs network.
Details how to connect the display to a sonar module (DSM) for fishfinder applications.
Guides through checking radar operation, including scanner initialization and transmission.
Provides causes and corrective actions for common marine electronics installation problems.
Lists problems, causes, and solutions for issues encountered during power-up.
Addresses common radar problems like 'No Data' or incorrect bearing alignment.
Diagnoses and resolves issues related to the GPS status icon and connection.
Troubleshoots common sonar issues like 'No data' or problematic depth readings.
General