63
Off/Not Connected
If the ‘Off/Not Connected’ message is displayed then the display
cannot establish a connection with your radar scanner:
Ensure that your display and radar scanner are paired correctly and
then select
On to power up your radar.
If the ‘Radar not found’ message is displayed then power cycle your
system and perform the pairing procedure again. If the radar scanner
still cannot be found refer to your Radar’s installation documentation
for further troubleshooting information.
Off
If the ‘Off’ message is displayed then your radar scanner is powered
off, select
On to power up your Radar
Standby (Not transmitting)
If the ‘Standby’ message is displayed then select Transmit to begin
transmitting.
To Next Page
Loading...
Need help?
General