Raymarine SmartPilot ST6001 User Manual

Chapter 2: SmartPilot Commissioning 23
Enter Dealer Calibration mode
As improper use of the Dealer Calibration settings can seriously impair SmartPilot
performance, we have made entry to the Dealer Calibration mode more difficult.
Ensure you follow the instructions in this step carefully.
1. Start with the SmartPilot in STANDBY mode.
2. Enter DEALER CAL as follows:
Note: For more information on SmartPilot settings, refer to Chapter 3:
Set the vessel type
When you select a vessel type, the SmartPilot automatically selects appropriate
default values for various other calibration settings.
Some of these settings will be checked later in this procedure and the remained
should not require any adjustment. The default values for each vessel type are
listed on
page 57 .
ST6001/ST6002 Controllers ST7001 /ST7002 and ST8001/ST8002
Controllers
• press and hold the standby key for two
seconds to enter the Calibration mode
• when the screen shows
DISPLAY CAL,
press the disp key until you see the
DEALER CAL screen
•press the auto key: the display will
change to
CAL?
•press -1 and +1 together to enter Dealer
Calibration mode
• press and hold the standby key for two
seconds to enter the Calibration mode
• when the screen shows DISPLAY CAL,
press the disp, up or down arrow
key until you see the DEALER CAL
screen
• press the auto key: the display will
change to
CAL?
•press -1 and +1 together (ST7001/
ST7002) or press up and down arrow
keys together (ST8001/ST8002)
to enter Dealer Calibration mode
At the CAL ? screen, press + together to enter DEALER CAL
2 sec
x3
-1 +1
or
D6322-2
(ST8001 & ST8002 only)
+
81273_1.book Page 23 Thursday, November 10, 2005 8:25 AM

Raymarine SmartPilot ST6001 Specifications

General

Brand	Raymarine
Model	SmartPilot ST6001
Category	Marine Equipment
Language	English