Chapter 3: Adjusting SmartPilot Settings 47
Dealer Calibration screens and settings
The items in Dealer Calibration vary according to the vessel type you have
selected. See the table on
page 57
for default values.
SeaTrial Calibration lock
This screen controls whether it is possible to access Seatrial Calibration.
Vessel type
Vessel type should be set when commissioning the SmartPilot (see
page 23
).
Notes: (1)
When you select the vessel type, the SmartPilot will set appropriate de-
faults for several other calibration settings. Refer to the table on page 57
for default values.
(2)
The vessel type options will normally give optimum performance for typical
vessels of each type. However, you may find you can improve the
performance of your vessel by selecting an option for a different vessel
type.
Options
CAL LOCK OFF
Calibration lock off – Seatrial calibration can be accessed
(default)
CAL LOCK ON
Calibration lock on – Seatrial calibration cannot be
accessed
Options
DISPLACE
Power-driven boats which do not plane
(Typically below 15 kts top speed)
SEMI DISPLACE
Faster power-driven boats which do not plane
(Typically 15-20 kts top speed)
PLANING
Planing boats with inboard engine(s) and shaft drives
(NOT boats with outdrives)
STERN DRV
Boats with outdrives or outboard engines, including Mer-
cury Verado and Volvo Penta IPS.
WORK BOAT
Commercial tugs, fishing vessels, etc
SAIL BOAT
Sailing boat
81273_1.book Page 47 Thursday, November 10, 2005 8:25 AM
To Next Page
Need help?
General
