22 ST60 Tridata Instrument Owner’s Manual
6. Screw the two fixing studs (1) into the threaded sockets on the rear of
the instrument.
7. Mount the assembled instrument, studs, bezel and gasket into the
panel.
8. Locate the flush mount bracket (6) onto the fixing studs and secure
the assembly to the panel with the thumb-nuts (5).
Bracket mounting
A Control Unit Mounting Bracket (Part No. E25009) enables you to
mount your ST60 instrument in locations whereother forms ofmounting
are impractical. Although this provides a useful alternative method for
securing your instrument, it is only suitable for use in positionswhere the
instrument will not be exposed to water.
To bracket mount your ST60 instrument, do so in accordance with the
Control Unit Mounting Bracket Instruction Sheet.
Flush mounting
D5462-1
113
4
556
81040_1.book Page 22 Thursday, November 7, 2002 10:21 AM
To Next Page
Loading...
Need help?
General
