Calibration 41
Boat show mode
CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF. If necessary, use the
trip or reset key to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory
default values. If you want to apply the factory defaults, ensure the
display shows YES, but if you want to retain the values you have set up,
ensure that the display shows NO.Usethe
trip and reset keys to makethe
required selection.
The values you have selected will be applied when you exit this screen.
Leaving Dealer calibration
Hold downthedepth and speed keys for 2 seconds to save your settings,
exit Dealer calibration and resume normal operation.
81040_1.book Page 41 Thursday, November 7, 2002 10:21 AM
To Next Page
Loading...
Need help?
General
