Record g
Install the Clock Lithium Cell
The clock cell indicator d_ will appear on the LCD monitor or in the viewfinder when
the cell has not been installed or needs to be replaced. The cell should last
approximately one year.
Insert object here to remove cell.
CockCe
(+ Side Facing Out)
Clock Cell
Compartment
1. Make sure camcorder is turned off, and
remove any power supply attached to
the camcorder.
2. Press release tab of clock cell compart-
ment cover and open the compartment.
3. Insert the clock cell with the "+"
terminal facing out.
4. Close the compartment cover. It will
click into place.
To Remove Cell
To remove cell, insert a pointed non-
metallic object between cell and
compartment and lift.
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell- such as
CR2025. Use of other cell presents a risk of fire or explosion. Must be disposed
of properly. Never handle punctured or leaking cell. May cause bums or
personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If
swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical
burn if mistreated. Do not recharge, disassemble, heat above 212°F (100°C), or
incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and -
sides of the cell.
42
To Next Page
Loading...
Need help?
General
