14
USING THE SCANNER
NOTE: Remember that the monitor memories are not
scannable. If you decide you want to store an active
frequency, you will have to move it to one of your
scanner’s 200 permanent stored channels. (See “Moving a
Frequency From Monitor Memory to a Permanent
Channel.”)
To store a frequency:
When the scanner stops on an active frequency and
you want to temporarily save it, press the MON
button to store it in the monitor memory with the
flashing indicator beneath it.
If you do not want to save the active frequency, press
either
or to continue the search.
RETRIEVING A MONITOR MEMORY
Since you cannot scan monitor memories, you must
manually select the frequency you want to hear.
1. Press the MANUAL button.
2. Press the MON button.
3. Press the number key of the monitor memory
location you want to hear.
MOVING A FREQUENCY FROM
MONITOR MEMORY TO A CHANNEL
When you decide you want to store one of the active
frequencies you have temporarily held in monitor
memory, your scanner has permanent storage
locations, called channels.
1. Press the MANUAL button and then enter the
channel number into which you want to store the
monitor frequency.
2. Press the PGM button, then the MON button and
then enter the number of the monitor memory
location that has the frequency you want to
permanently store.
To Next Page
Loading...
Need help?
General
