Revision 2.6 Page 22 of 53
Intuitive Mercury 6-5M Controller with TDB
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Analogue Output
Digital Input
Type is Fixed
Board will be 0
Input: Select which input is to be used from
the drop-down menu (This will be one of the six probe
inputs)
Define allows the switching threshold to be changed, this is
defaulted to 1000 ohms. When the inputs detects a resistance
greater than 1000 ohms then the input is seen as open circuit, if
the input is less than 1000 ohms then it is seen as closed circuit.
Type is fixed
Board: Will be 0
Output: Will be Volts Output or mA
Output, depending on daughter board
fitted.
Analogue outputs need to be defined
“Output Mode” is fixed as V or mA
depending on daughter board fitted.
Define an input value to the block and
the output value. There are 11 define
points, and between points there is a
linear interpolation.
To Next Page
Loading...
Need help?
General
