Revision 2.6 Page 8 of 53
Intuitive Mercury 6-5M Controller with TDB
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Daughter Board Connection Details
Note: “PWR” is a constant voltage output for external equipment, supply voltage is dependent on the board type, see the specification section
for more details. GND is a common ground for all inputs and outputs.
Ordering Information
When ordering a Mercury Intuitive TDB controller the following ordering scheme can be used to purchase the desired hardware configuration.
This ensures the controller ships with the optional hardware pre-fitted.
PR07VW X TDB Y Z Where W, X, Y and Z are selections from the tables below;
Relays 1, 2 & 3 Solid State
3 x Temperature Probe Inputs
WiFi Interface with Internal Antenna
1 x 0-5V/0-10Vdc Input & 1 x 0-5V/0-10Vdc Output
WiFi Interface with External Antenna
1 x 0-5/0-10Vdc Input & 1 x Probe Input
1 x 4-20mA Input & 1 x 4-20mA Output
3 x Input High Speed Pulse Counter
** If no daughter card required leave field blank
1 x 4-20mA Input & 1 x Probe Input
Example – To order a remote display variant with a mechanical relay in position 1, a built in IP module and a high speed pulse counter board
use the following part number: -
PR0760 TDB IP 3HSP
3x Temperature Probe Input
3x Input High Speed Pulse Counter
1x 0-5V/0-10Vdc Input & 1x 0-5V/0-10Vdc Output
1x 0-5/0-10Vdc Input & 1x Probe Input
1x 4-20mA Input & 1x 4-20mA Output
1x 4-20mA Input & Probe Input
To Next Page
Loading...
Need help?
General
