Revision 2.6 Page 38 of 53
Intuitive Mercury 6-5M Controller with TDB
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Input A: Analogue input
Input B: Set Point
Input C: Diff above SP
Input D: Diff below SP
On Off On
Set Point
Diff above
Diff below
Output
The block is used to detect the rising and falling edge of a digital signal.
Edge On the rising edge of the input signal the “Edge” and “Rising” outputs will
pulse Hi for 0.1 seconds
Rising On the falling edge of the signal input the Edge and Falling Outputs will
pulse Hi for 0.1 seconds
The use of a SR-Latch on each output may be required.
Description
For any Rise on the Signal Input
The Edge and Rising Outputs will pulse high for 0.1 seconds
For any Falling Edge on the Signal Input
The Edge and Falling Outputs will pulse high for 0.1 seconds
The use of a SR-Latch on each output may be required.
To Next Page
Loading...
Need help?
General
