- 149 -
MULTI TYPE
2, 3, 4 ROOMS TYPE
13-3. Indoor unit (setting by wired remote controller)
• The function settings of the control of the indoor unit can be changed by this procedure
accord
ing to the installation conditions. Incorrect settings can cause the indoor unit malfunc-
tion.
• After the power is turned on, perform the “FUNCTION SETTING” according to the
installation
conditions using the remote controller.
•
The settings may be selected between the following two: Function Number or Setting Number.
• Settings will not be changed if invalid numbers or setting numbers are selected.
• This function cannot be used on the secondary units.
Preparation
Before connecting the power supply of the indoor unit, reconfirm following items:
• Piping air tight test and vacuuming have been performed firmly.
• There is no wiring mistake. Then, connect the power supply of the indoor unit.
Breaker on
Outdoor unit
Indoor units
To Next Page
Loading...
Need help?
General
