- 256 -
OUTDOOR UNIT
ROMH24AFXZJ
14. Installation precautions
14-1. Outdoor unit installation precautions
NOTE: The information listed below are general precautions.
Some models also include items that do not apply.
Place where use prohibited use
• Places where there is a danger of combustible gas leakage.
• Places where sulfur gas, chlorine gas, acid, alkali, or other matter which effects equipment
is
g
enerated.
• Places not affected by heat radiation from other heat sources.
• Places where the air is not stagnant.
• Places where machinery which generates high frequencies is used.
• Ocean beaches and other areas where there is a lot of salt.
• Inside of vehicles, ships, and other conveyances.
• Places where voltage fluctuations are product.
Points to remember when installing
• The product shall be installed at a place which can withstand the weight and vibration of the
o
utdoor unit.
• To allow maintenance after refrigerant piping, dr
ain piping, and electric wiring connection and
insta
llation, provide an installation service space.
*Installation service space is shown on “Installation space” on page 217.
• Be careful when installing the set at the following places.
Condition Contents Countermeasures (Reference)
When
installed near
adjacent
houses.
Perform installation work so that operating sound
does not disturb the neighbors.
1.
Install a soundproof barrier.
2.
Change the installation site.
When there is
the possibility
of strong
wind.
• If the outdoor unit is exposed to strong wind,
capacity may drop, frost may form during heating
,
a
nd operation may be stopped by high pressure
rise. In addition, when a very strong wind
blows,
the fan may be
damaged.
• When a very strong wind blows, there is the possi-
bility of the outdoor unit being toppled ov
er if held
only
by foundation bolts.
1.
Install the outdoor unit
with
keeping a suffici
ent
distance
between
the
outlet side of the
unit and a facing
wall or fence.
2.
Make the outlet direction
and
wind di
rection perpendicular.
3. Fasten the outdoor unit using
toppling prevention hardware
(purchased locally).
When snow
accumulates.
If the outdoor unit is covered by accumulated snow, it
may not be able to operate.
1.
Make the foundation as
high
as possible.
2. Perf
orm snow pr
evention
work
.
When
installing the
inverter type.
It may generate noise in TV sets, stereos and PCs. The inverter type should be
installed at a sufficient distance
from these equipments.
To Next Page
Loading...
Need help?
General
