Ricoh 4051 General Settings Guide

Getting Started
26
1
Turning Off the Power
A
AA
A
Press the operation switch.
The On indicator goes off.
Note
❒ In the following cases, the indi-
cator will not go off but will in-
stead blink when you press the
operation switch:
• During communication with
external equipment.
• When the hard disk is active.
Turning Off the Main Power
Important
❒ Do not turn off the main power
switch when the On indicator is on
or blinking. Failure to observe this
may result in damage to the hard
disk or memory, leading to mal-
function.
❒ Be sure to pull out the power cord
only after you have turned off the
main power switch. Not doing this
may result in damage to the hard
disk or memory.
A
AA
A
Make sure the On indicator is off.
B
BB
B
Open the switch cover, and turn
off the main power switch.
The main power indicator goes off.
Saving Energy
-
--
- Energy Saver Mode
If you do not operate the machine for
a certain period of time, or when you
press the {
{{
{Energy Saver}
}}
} key, the dis-
play disappears and the machine
goes into Energy Saver mode. When
you press the {
{{
{Energy Saver}
}}
} key
again, the machine returns to the
ready condition. The machine uses
less electricity in Energy Saver mode.
Note
❒ You can change the amount of time
the machine waits before switch-
ing to Energy Saver mode after
copying has finished or the last op-
eration is performed. See p.59 “En-
ergy Saver Timer”.
ZGVS310E
ZGVH471E
MartiniC2_GBzen_F_pre_FM.book Page 26 Thursday, October 21, 2004 5:07 PM

Ricoh 4051 Specifications

General

Brand	Ricoh
Model	4051
Category	All in One Printer
Language	English