59
5. Remarks
Do's and Don'ts
CAUTION:
• If you use this machine for a long time in a confined space with poor ventila-
tion, you may detect an odd smell. To keep the workplace comfortable, we
recommend you keep it well ventilated.
• Do not touch areas on or around the fusing unit. These areas get hot.
• After continuous copy runs, you may notice the exposure glass warming.
This is not a malfunction.
• The area around the ventilation hole may feel warm. This is caused by ex-
haust air and is not a malfunction.
• Do not turn off the operation switch while copying. When turning off the op-
eration switch, copying with memory will continue. However, scanning of
originals is interrupted.
• The machine might fail to produce good copy images if condensation forms
inside the machine due to rapid temperature change.
• Do not open the covers of the machine while copying. If you do, misfeeds
might occur.
• Do not move the machine while copying.
• If you operate the machine improperly or a mechanical failure occurs, settings
might be lost. Be sure to make a note of your machine settings.
• The supplier shall not be liable for any loss or damage resulting from mechan-
ical failure, loss of settings, or use of the machine.
• Unplug the power cord from the wall outlet before you move the machine.
While moving the machine, you should take care that the power cord will not
be damaged under the machine.
KirC1a_AE_F_FM.book Page 59 Friday, January 31, 2003 4:54 PM
To Next Page
Loading...
Need help?
General
