11. Appendix
This section explains maintenance and operation procedures for this printer. It also describes the
specifications of the printer and its options.
Moving and Transporting the Printer
• If the machine topples, or if a cover or other part gets broken, you must turn the power switch to
off and disconnect the power cord plug from the wall outlet. Then contact your service
representative and report the problem. Do not use the machine. Doing so could result in fire or
electric shock.
• The printer weighs approximately 23 kg (51 lb.). When moving the printer, use the inset grips on
both sides, and lift slowly in pairs. The printer will break or cause injury if dropped.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling
the cord can damage the power cord. Use of damaged power cords could result in fire or electric
shock.
• Unplug the power cord from the wall outlet before you move the machine. While moving the
machine, take care that the power cord is not damaged under the machine. Failing to take these
precautions could result in fire or electric shock.
• Be sure to disconnect all cables from the printer before transporting it.
• The printer is a piece of precision machinery. Take care to avoid damage during transportation.
• If optional paper feed units are attached, remove them from the printer and move them separately.
Moving the Printer in a Short Distance
1. Be sure to check the following points:
• The power switch is turned off.
• The power cord is unplugged from the wall outlet.
209
To Next Page
Loading...
Need help?
General