Replacing Other Consumables
Refer to the maintenance guide provided with the new items for the replacement.
• The fusing unit becomes very hot. When installing a new fusing unit, turn off the printer and wait
at least an hour after power off before replacing parts. Not allowing the printer to cool may
result in burns.
• When taking the development unit out of the box, be sure to hold the unit by the handle on the top
of the unit. Do not touch any parts of the development unit.
• Exposure to light reduces development unit performance. Replace the unit as quickly as possible.
• Do not pull out the development unit quickly or with force as it may fall.
• Take care that nothing comes into contact with the photo conductor area of the development unit.
• Place no objects on the front or inner cover.
Maintenance Kit A
Replace the Maintenance Kit A when the following message appears on the display:
"Replacement of Maintenance Kit A is now necessary. Replace Maintenance Kit A"
When the following message appears on the display, the Maintenance Kit A should be replaced
soon.
"Replace Maintenance Kit A. Press either the Check Status key or the remaining supply display to
check information about supplies."
Maintenance Kit B
Replace the Maintenance Kit B when the following message appears on the display:
"Replacement of Maintenance Kit B is now necessary. Replace Maintenance Kit B"
When the following message appears on the display, the Maintenance Kit B should be replaced
soon.
"Replace Maintenance Kit B. Press either the Check Status key or the remaining supply display to
check information about supplies."
4. Replenishing and Replacing Consumables
124
To Next Page
Loading...
Need help?
General