Ricoh IM 9000 User Manual

2023/05/01 14:32
Access Control | User Guide | IM 7000, IM 8000, IM 9000
https://support.ricoh.com/services/device/ccmanual/IM_7000-8000-9000-re/en-GB/security/int/control.htm
2/12
Specify the range of the IP address that can access the machine by using Web Image Monitor.
You can limit access from the following protocols.
LPR, RCP/RSH, FTP, Bonjour, SMB, WSD (Device), WSD (Printer), WSD (Scanner)/DSM,
IPP, DIPRINT, RHPP, snmp, telnet, NBT
The machine also limits access from Web Image Monitor.
Logging in to the Machine as the Administrator
To specify an IPv4 address, enter a range that has access to the machine in [Access Control
Range].
To specify an IPv6 address, select [Range] or [Mask] in "Access Control Range", and then enter a
range that has access to the machine.
Log in to the machine as the network administrator from Web Image
Monitor.
Click [Configuration] on the [Device Management] menu.
Click [Access Control] in the [Security] category.
In "Access Control", click [Active] and specify the range of IP addresses
that have access to the machine.
Click [OK].
Log out of the machine, and then exit the Web browser.
Protocol Setting Method List

Ricoh IM 9000 Specifications

General

Resolution	1200 x 1200 dpi
Paper Capacity (Maximum)	8, 700 sheets
First Output Speed	3.9 seconds
Paper Input Capacity (Standard)	4, 300 sheets
Paper Weight	52 - 300 g/m²
Duplex Printing	Standard
Standard Memory	2 GB
Hard Disk Drive	320 GB
Power Source	220 - 240 V, 50/60 Hz
Maximum Paper Size	SRA3
Operating System Compatibility	Windows, Mac OS, Linux
Print Speed	90 ppm
Paper Size	A3, A4, A5, B4, B5
Processor	Intel Atom Processor Bay Trail
Network Connectivity	Ethernet 10 base-T/100 base-TX/1000 base-T, USB 2.0