d Adding Staples
141
6
Staple unit for saddle stitch function
❖ Using “Prepare Stapling ”in User Tools to initialize the staple unit
When the booklet finisher is installed, make sure to initialize the staple unit
for the saddle stitch function with User Tools after adding staples or removed
jammed staples. If you do not do this, copies may not be stapled and misfeeds
may occur.
Reference
p.54 “Prepare Stapling”
A Press the {User Tools/Counter} key.
B Press [System Settings].
C Press [Prepare Stapling ]on the menu of General Features 2/2.
D Press [OK].
The machine staples five to seven times without ejecting staples.
E Press [Exit].
F Press [Exit].
• 1: Open the front bottom cover of the fin-
isher.
• 2: Pull lever R7 and fully pull out the staple
unit.
• 3: Lift the lever of the staple unit while
pulling it.
• 4: Take out the empty cartridge.
• 5: Set the new cartridge.
• 6: Bring the staple unit back into place.
• 7: Close the front bottom cover of the fin-
isher.
ZBQP070E
ZBQP080E
ZBQP090E
AdonisC4-AE_zen_F_FM_forPaper.book Page 141 Thursday, May 12, 2005 3:32 PM
To Next Page
Loading...
Need help?
General
