3. Clearing Misfeeds
This chapter describes what to do if a paper jam (misfeed) occurs.
Removing Jammed Paper
This section describes how to locate and remove jammed paper.
• The inside of the machine could be very hot. Do not touch any parts other than specified in this
document when removing misfed paper. Otherwise, it may cause burn injury.
• The fusing section of this machine might be very hot. Caution should be taken when removing misfed
paper.
• Keep your hands clear of the booklet finisher tray when pulling out or pushing in the finisher's staple
unit. You can trap your fingers if you do not.
• When clearing misfeeds, do not turn off the operation switch. If you do, your settings will be lost.
• To prevent misfeeds, do not leave any torn scraps of paper inside the machine.
• Contact your service representative if misfeeds occur frequently.
Locating Jammed Paper
If a misfeed happens, remove the misfed paper following the procedures stated on the sticker inside the
finisher or front cover.
The location of the paper jam (misfeed) is indicated by the letter shown on the displayed panel.
47
To Next Page
Loading...
Need help?
General
