Convenient Usage
51
Roll to Cut function
It can be used as Roll to Cut mode by changing the RIP settings.
Media is wasted at each cut approximately 770 mm (30.31in), when default setting.
In order to prevent the abnormal image by the media deformation, the default setting is not
to rewind the media.
However, if you want to reduce the lost media, turn on the “Auto Rewind function after Auto
Cut “. It can reduce up to 600mm of waste media for each cut.
* Available with FW V1.07 or higher. If you cannot find this function, please contact your
service representative.
Caution
Depending on the media, the image quality may be significantly degraded due to the
deformation of the media due to heat, so please test with the media in advance.
* The above dimensions are approximate and cannot be guaranteed.
To Next Page
Loading...
Need help?
General
