Ricoh Scanner Scanner Guide

Various Scan Settings
114
6
Scanning Part of an Original
This section explains how to set a custom size for scanning an area within an
original.
To scan a section of an original, measure Original Size (X1 and Y1), Start Position
(X2 and Y2), and Scan Area (X3 and Y3) on the surface of the original, and then
enter those values in the same order. Measuring methods differ depending on
the original’s orientation and the position it is set in. The following example
show how to measure the size in order to scan the section marked “R”. Refer to
the following examples to measure each size correctly.
The procedure below explains for scanning the "R" area of the original.
A Press [Scan Settings].
B Press [Scan Size].
C Press [Custom Size].
ATF008S

Ricoh Scanner Specifications

General

Brand	Ricoh
Model	Scanner
Category	Scanner
Language	English