To Next Page

To Previous Page

Delivering Scan Files

Preparing to Deliver a File

This section describes the preparations and settings for delivering scan files.

Important

❒ To use the network delivery scanner function, you need a delivery server on

which the optional the ScanRouter delivery software is installed. For details

about the ScanRouter delivery software, see the manuals supplied with the

ScanRouter delivery software.

❒ To view files delivered to an in-tray, DeskTopBinder must be installed on the

client computer.

A Connect the machine to the network.

Connect the machine to the network using an Ethernet cable or wireless LAN

(IEEE 802.11b).

B Make the necessary network settings in [System Settings].

If you have connected the machine to the network using an Ethernet cable,

make the following settings. For details, see General Settings Guide.

• Specify the machine’s IPv4 address and subnet mask

•In [Effective Protocol], enable [IPv4]

•Set [Delivery Option] to [On]

C If necessary, change settings in [Send Settings] under [Scanner Features].

D Using the ScanRouter delivery software, register this machine as an I/O de-

vice. In addition, specify register destinations and specify such settings as

the delivery type and sender.

For details, see the manuals supplied with the ScanRouter delivery software.

Note

❒ To connect the machine to the network using a wireless LAN (IEEE 802.11b),

an extended wireless LAN board is required respectively. For details, see

Network Guide.

❒ Items to set up in [System Settings] vary depending on the network environ-

ment. For details about the network settings, see General Settings Guide.

❒ For details about installing DeskTopBinder Lite, see "Installing DeskTop-

Binder Lite from the Supplied CD-ROM".

Reference

p.85 “Installing DeskTopBinder Lite from the Supplied CD-ROM”

Ricoh Scanner Scanner Guide

Other manuals for Ricoh Scanner